INTRODUCTION
Automatic night light control system
Automatic night light control system needs no manual operation for switching ON and OFF when there is need of light. It detects itself whether there is need for light or not. When darkness rises to a certain value then automatically light is switched ON and when there is other source of light i.e. day time, the light gets OFF.
In the project we use light detecting resistor as a light sensor & a NAND gate for detection of high level or low level of voltage to energize the RELAY coil which is used to interface the control circuit with the external light source.
Wastage of power is not desirable in any system. So it is very much economic to have this arrangement so that power is not wasted during day time where manual operation is not possible. Though we can use it in our daily life also for the betterment of our system.
While dealing with this project we faced a problem that the light remained on or off depending upon the presence of any other light source. If we want to make the light off in night hours when there is no need of light, or after switching off the light if we want to make the light on again it was not possible with the circuit investigated earlier. As we don’t want any manual operation we have an arrangement of doing this by means of sound (like clapping sound).This mechanism makes the circuit is more flexible.
By means of this circuit we can control any other electrical appliances as we use the double pole double throw relay switch.